【沙特重大更新】沙特进口管制要求&产品图片要求更新

沙特标准和计量组织（SASO）宣布，自7月22日起，非管制内产品（新旧注册）必须上传产品图片，因此，所有旧的非管制产品注册都将无效。必须重新申请带有 3 张照片的新注册。并且对于管制产品，也将从7 月 24 日起强制要求上传产品图片。以下是对图片的要求：

- 清晰的产品标签图片。

- 清晰的产品条形码/二维码图片。

- 显示产品的形状，以及每个型号的图片（如有）。

- 商标图片

- 能效标签图片（如有）

另SC有效期已更新为两个月.

From July 21st, photos upload is mandatory for non – regulated items (new and old registrations) Hence, all old non-regulated registrations will be invalid. New registrations with 3 photos must be reapplied. Images upload for regulated items will be mandatory starting July 24th. Below are the requirements for the images:

- A clear image of the product label.

- A clear image of the product barcode / QR code.

- An image shows the identity and the shape of the product, and an image of each model (if any).

- An image of the trademark

- An image of energy efficiency label (if any)

Shipment certificates validity has been updated to 2 months from issuance.

根据沙特标准和计量组织（SASO）最新要求，从 2022 年 7 月 31 日起，以下四类产品在申请SC时，所有进口商都必须填写随附的“制造商/进口商申报表”，提交给沙特工业和矿产资源部。得到批准后，方可继续申请SC。

SASO 强调，一旦申请人提交，他们将验证并确认该文件的存在，除非申报表得到工业和矿产资源部的批准，否则不允许通过SABER系统批准 SC。

请注意以下产品同样有工厂审核的要求:

SASO just recently announced that starting on 31/07/2022 AD, all Importers shall be required to fill out the attached “Manufacturers/Importers Declaration Form” to be submitted to Minister of Industry & Mineral Resources for their approval prior to process the Shipment Certificate of Conformity (SCoC) for the covered 4 products as shown below table.

Accordingly SASO emphasizes that they will verify and acknowledge the presence of this document once submitted by the applicant, knowing that it is not allowed to approve a SCoC thru Saber system unless the form is approved by the Ministry of Industry & Mineral Resources.